Plywood Side And Bottom
Determine the depth of the cutout ki Ihe frones for the bottom battens h the fame way ox for planted construction, hgww It Is vary Important that the itra^tedg© Is placed In the «me angle to the hog as shown on trie previous page,
Fasten the bottom battens wtth stainless steel scwvh 5*63, rf^J Cut from
IT rec^itred because of tvjfct and band fcrwofd, mats thij y 64x143
part urtth two laminations 15x44 scarfed lo Ihe ah batten. Tab aft
Check again bevel at hog and chins by using a sheet 8nd yy cy 4 ■ 6 mm plywood 300 k 120D and bending /
in poitfton.
By using a ladder as tfiown determhe Qj *
the approximate shape of the bottom /W ^VA
shoe! Ht the sheel by uting cumps and tempofary screw and mod j^wl^^yy^^x^*^^^ /Xa^ JyvS
the correct shape, jfir
Rk the side battens ond jffi^W
acfust the bevel at the chine j^T^O^rSa^ /sK
Waterway
Nalspaclng
Use temporary screws where the bend b had. F1 hale with epcwv ffltef.
Forward ihe bottom ptan/king
Change from oupitapping the side planking to butting against It
If using hoi dp galvanized nails 2.36 x 30, It* at angle.
The keel can be bated fWng Ihe bottom panel before o after as metered
Mart and transfer to plywood
Make the (odder ot plywood 4- 6 mm. Glue and nail together.
Post a comment